JOB DESCRIPTION:
- Before operating check working conditions. If any problem, must inform the Supervisor.
- Check the billets in the oven and start the billet heater.
- After the dies are loaded, check the correct number of dies loaded. He must also correct the bolster, shim, strike and cavities.
- Check the temperature of the billet, die oven and container.
- Set run-out table according for the profile geometry.
- Read the temperature and select from it which die is to be extruded first.
- Set the puller lengths and speed required for running.
- Select the proper cooling for the section.
- Make sure and record the time when the cleaner block is pushed (once every shift/change of alloy (Hard to soft)).
- Assume the duties of Shift Supervisor during his absence.
QUALIFICATIONS & EXPERIENCE:
- GRADUATE OF MECHANICAL ENGINEER
- Minimum experience of two years in the same field of work.
Job Types: Full-time, Permanent
الإبلاغ عن وظيفة